Controller Assembly for a 1.5 HP Motor


$1,789.00

Please Choose:

Shipping Included?




Add to Cart:


  • Description
  • Details
  • Reviews

* Controller Assembly for a 1.5 HP Motor with 55' cable to power the motor.

* Designed for use only with a 1.5 HP, 220VAC 3 Phase Motor.

* Controller converts 110VAC to 220VAC 3 Phase power to the motor.

* Controller has an 8 foot 110VAC power cord.

* Controller has 20 second ramp up Start and ramp down Stop, plus Variable Speed and Reverse.


The Electronic Variable Speed Controller you have received from Pro Walk is sold and serviced as an assembly, including the power supply cord for 110VAC service, and the controller cord which supplies power from the controller to the walker motor. This unit is sealed at the factory to prevent tampering with the control unit by anyone in the field. This is not a field service item.

ELECTRICIANS ARE NOT TO OPEN THIS UNIT, OR ATTEMPT ANY ADJUSTMENTS OR SETTINGS. ANY DISTURBANCE OF THE FACTORY SEAL WILL VOID ALL WARRANTY.

Installation

1) Mount unit a minimum of 2" from flat surface to allow proper air circulation.
2) Protect top of controller from weather.
3) Protect face of controller from direct sunlight.
4) Use minimum of 1 1/4" conduit for power cord from the controller to the motor.
5) Controller must have a minimum of 20 amps of electrical service at the controller.
6) GFI service is not compatible with this controller.
7) Unplug controller from 110VAC power source when not in use.
Following these basic guidelines will increase the service life of the variable speed controller.
  • Model: PW1.5HP

Be the first to write a review.  Write a Review.